ThermaCell E Series User Manual

minutes you will be protected from mosquitoes in the surrounding area.

When finished using it just turn it off. It's that easy. No sprays to wash

off and no candles to blow out.

3. Using Your Repeller

Press the power button to turn on.

The repeller will sound with an ascending tone and the battery

indicator will illuminate with current battery level. The repeller will

then display a chasing pattern of light indicating it is starting to

heat up. Once temperature is reached the ring will stay illuminated.

It can take up to 15 minutes for the Zone to fully establish.

To turn off press and hold the power button for two seconds:

You will hear a descending chime and all lights will turn off.

Press power button to turn on and off.

In the Box

1 E-Series Zone Mosquito Repeller

1 E-Series Zone Mosquito Repellent Refill

1 USB Cable

Diffuser Vent

Power Button

USB Port under

power button

Control Panel

Your repeller will communicate different statuses through the control

Power Button - Turns device on and off.

Status Indicator - A visual communication tool that lets you know the

repeller status. No need to pick up the device or get close to check.

Chasing Pattern: Unit is warming up

Solid Illumination: Unit is up to temp/

Actively releasing repellent

1. Getting Started

Your repeller has a rechargeable battery. Prior to first use, fully charge

the battery. To charge the battery pull back the rubber cover to expose

the USB charging port located on the front of the repeller. Insert the

charging cable provided with the repeller. The battery indicator is

located below the power button.

Battery Indicator Light

Fully Charged:

Low Battery (Less than 20 minutes):

Battery Too Low to be Turned On: Flashes

4. Place Your Device

Repeller is best placed in the center of the desired Zone of repellency.

If it is windy, place the repeller upwind of where you are sitting.

Only operate with vent facing up.

Do not cover repeller while it is in use.

To protect larger areas use multiple repellers.

2. Inserting a Repellent Refill

Remove top from repeller: To remove the top grasp the repeller

base with one hand and remove the top with the other.

Remove the cap from a Repellent Refill.

Insert the Repellent Refill into the repeller.

Replace the repeller top taking care not to damage the Repellent

Refill wick. The repeller uses magnets to hold the top to the

bottom of the device.

Use only Thermacell Repellent Refills.

Care & Storage

Do not store with battery completely discharged for

extended periods of time. Batteries should be charged at

least once every 3 months during storage.

Occasionally debris or condensation may build up on your repeller

device. Simply use a damp paper towel or rag to wipe away any

Do not expose the repeller to extended periods of rain or submerge

Do not expose the repeller to temperatures above 140°F.

Store at room temperature in a dry environment when not in use.

1-866-753-3837

service@thermacell.com

to help, 24/7

Thermacell Repellents, Inc.

26 Crosby Drive

Bedford, MA 01730 USA

Table of Contents

Related Manuals for ThermaCell E Series

Mosquito repellent with earth scent refills (2 pages)

Smart mosquito repellent system (9 pages)

Moaquito repellent (2 pages)

Mosquito repellent (2 pages)

Mosquito repellent (2 pages)

Mosquito repellent (2 pages)

Mosquito protection torch (2 pages)

Moaquito protection lantern (2 pages)

Mosquito repellent refill (2 pages)

Summary of Contents for ThermaCell E Series